Re: [Discuss-gnuradio] UHD with XCVR?

[Marius]

Hi Josh,

> There was some shuffling around with the uhd master branch for the 3.2
> releases. If you are running off the master, can you rebuild from the
> latest master (fc349d30507620baca935e75e68a9554b40d427c) and load the
> latest images (firmware and FPGA)
> http://www.ettus.com/downloads/uhd_releases/master_images/ I think that
> will solve your problem.

Loading the released binary images did not solve my problem. I tried them all.
The problem persists in the same way I described it.

Rebuilding the usrp2 firmware is with an issue too:

make[5]: Entering directory
`/home/marius/gnuradio_build/gnuradio/usrp/host/swig'
make[5]: *** No rule to make target `/usr/include/fpga_regs_common.h',
needed by `usrp_prims.py'.  Stop.
make[5]: Leaving directory `/home/marius/gnuradio_build/gnuradio/usrp/host/swig'
make[4]: *** [all-recursive] Error 1
make[4]: Leaving directory `/home/marius/gnuradio_build/gnuradio/usrp/host'
make[3]: *** [all-recursive] Error 1
make[3]: Leaving directory `/home/marius/gnuradio_build/gnuradio/usrp'
make[2]: *** [all] Error 2
make[2]: Leaving directory `/home/marius/gnuradio_build/gnuradio/usrp'
make[1]: *** [all-recursive] Error 1
make[1]: Leaving directory `/home/marius/gnuradio_build/gnuradio'
make: *** [all] Error 2

I'm not sure right now how to solve this...

Thanks for the points so far.

Best,
Marius