Re: [Discuss-gnuradio] USRP2 with WBX and LP0926 to receive GSM spectrum

[Marcus D. Leech]

On 10/05/2010 04:30 PM, hafiz zimran wrote:

Hi

We have received USRP2 with WBX and LP0926 PCB Antenna on 19 August,2010.

We are trying to receive GSM spectrum ( Above 900MHz) but we are getting the error USRP2: Channel 0 not receiving

USRP2: rx_samples(0 failed.

 

When we run the command sudo usrp2_fft.py -f 900M , we are getting the same error.

Below 900MHz, the above mentioned command is working ( we are able to see the spectrum).

Would you please guide us what the reason for error.

 

Best Regards

 

Zimran Rafique

 

_______________________________________________
Discuss-gnuradio mailing list
address@hidden
http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
  

Are you running the as-shipped firmware?  If so, it doesn't support the WBX.  You'll need to go
  here, and get the appropriate firmware and fpga load:

http://code.ettus.com/redmine/ettus/projects/public/wiki/U2binaries

-- 
Principal Investigator
Shirleys Bay Radio Astronomy Consortium
http://www.sbrac.org