[Discuss-gnuradio] USRP2 unable to receive signal at RX-B

[Cheaw Wen Guey]

Hi all,

I started testing my USRP2 at a lower frequency. I have a function
generator generate a 10MHz sine wave on RX-A and RX-B.

However, I am unable to see the signal when I run usrp2_fft.py. To
confirm, I disconnected the signal from RX-A and still nothing. I can only
trace the signal as far as the signal transformer as the ADC is under the
Basic-RX board.

Is the USRP2 only able to receive on RX-A or is the board defective?

Thanks in advance.

Cheaw Wen Guey
Research Officer