discuss-gnuradio
[
Top
][
All Lists
]
Advanced
[
Date Prev
][
Date Next
][
Thread Prev
][
Thread Next
][
Date Index
][
Thread Index
]
[Discuss-gnuradio] Frequency not set with ./multi_rx_streaming_samples -
From
:
xiong jie
Subject
:
[Discuss-gnuradio] Frequency not set with ./multi_rx_streaming_samples -f. Please help!
Date
:
Tue, 13 Apr 2010 00:33:28 +0100
I run the following comamnd:
./multi_rx_streaming_samples -e eth1 -f 5.180G -d 4 -g 20 -N 100000 -v -o newtest
However, frequency is not set as 5.180G. Basebad_freq is still set to 0.
Also, it stuck after 'Receiving 100000 samples' and never end..
Anyone has any idea?
I appreciate if anyone can help.
The detail error message is shown as below:
./multi_rx_streaming_samples -e eth1 -f 5.180G -d 4 -g 20 -N 100000 -v -o newtest
1 interfaces
make usrp on eth1
lock usrp 1/1 to SMA:
done
USRP2[0] MAC address: 00:50:c2:85:30:a1
Daughterboard configuration:
baseband_freq=0.000000
ddc_freq=20000000.000000
residual_freq=0.004657
inverted=no
USRP2 using decimation rate of 4
sync usrp 1/1 to pps:
done
start_rx_streaming_at usrp 1/1:
Receiving 100000 samples
reply via email to
[Prev in Thread]
Current Thread
[Next in Thread]
[Discuss-gnuradio] Frequency not set with ./multi_rx_streaming_samples -f. Please help!
,
xiong jie
<=
Prev by Date:
RE: [Discuss-gnuradio] Using a custom block
Next by Date:
Re: [Discuss-gnuradio] benchmark tx and rx help
Previous by thread:
[Discuss-gnuradio] usrp2_fft.py and changing the gain
Next by thread:
[Discuss-gnuradio] reuse c++ modules in c++ code
Index(es):
Date
Thread