[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Discuss-gnuradio] test_usrp_standard_tx Could not set frequency
From: |
Eric Blossom |
Subject: |
Re: [Discuss-gnuradio] test_usrp_standard_tx Could not set frequency |
Date: |
Tue, 8 Sep 2009 12:10:02 -0700 |
User-agent: |
Mutt/1.5.18 (2008-05-17) |
On Mon, Sep 07, 2009 at 03:39:33PM -0500, address@hidden wrote:
> Hello,
>
> I am new to the GNU Radio. I have been following the steps outlined in
> http://gnuradio.org/trac/wiki/UbuntuInstall, and I am at the point where I am
> testing.
> The command:
> ls -lR /dev/bus/usb | grep usrp
> shows a single USRP, which is correct.
>
> usrp_benchmark_usb.py
> Passes everything but the 32 Mb/s test.
>
> But when I try to run:
> test_usrp_standard_tx
> I receive this output:
>
> which: 0
> interp: 16
> rf_freq: -1
> amp: 10000.000000
> nsamples: 3.2e+07
> Subdevice name is XCVR2450 Tx
> Subdevice freq range: (2.4e+09, 6e+09)
> mux: 0x000089
> baseband rate: 8e+06
> Fail 4200000000.000000
> terminate called after throwing an instance of 'std::runtime_error'
> what(): Could not set frequency.
> Aborted
>
>
> This is on a USRP, with two XCVR2450 daughterboards. I looked through the
> wiki, mailinglist, and the web, but I did not find anyone who had this
> problem.
>
> Thank you for your help,
> Brian Proulx
The XCVR2450 covers 2.4-2.5 GHz and 4.9 to 5.85 GHz. Try tuning to
something in these ranges.
Eric