[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Discuss-gnuradio] ATSC Signal Receiving Output File Empty
From: |
ywang06 |
Subject: |
[Discuss-gnuradio] ATSC Signal Receiving Output File Empty |
Date: |
Thu, 11 Jun 2009 11:56:40 -0400 |
User-agent: |
Internet Messaging Program (IMP) 3.2.8 |
Hi Everyone,
I recently begin to use GNU Radio to receive ATSC signal. The GNU Radio version
is the most updated Developer version on Ubuntu 9.04. I followed the steps of
README in /gnuradio/gr-atsc/src/python/. I set the frequency to be 557M
decimation to be 10 and number of samples to collected to be 200M. There is no
overrun or under run during collecting the data. After excuting
interp_short.py, xlable.py, fpll.py, btl-fsd.py and viterbi-out.py, the output
file is empty. I set each of the py programs to output file, and saw that the
output of btl-fsd.py is empty. There were someone posting a similar question on
the disscussion list, but I didn't find the answer to that. Do you have any
opinion about this? Is the parameters setting causing the problem or I am
operating this incorrectly?
Thanks a lot!
Ying
- [Discuss-gnuradio] ATSC Signal Receiving Output File Empty,
ywang06 <=