I have just replaced the DX2 chip and in the process lifted two pads.
They are pins 25 (T2) and 86 (PE0).
Looking at the cct diags that one can get from the cvs it appears that
pin 25 is not connected to anything else but 86 should be. (By the
square blob on the end of the signal wire) I cant however find any
reference to that signal on any of the usr cct diagrams.. The netlist
shows it has no connection elsewhere .. I dont quite know what to
believe...
Can anyone tell me if indeed PE0 goes anywhere?
Tnxs Bob VK2YQA
|