Re: [Discuss-gnuradio] usrp2_fft segmentation fault

[Eric Blossom]

On Fri, Oct 24, 2008 at 10:39:26AM +0200, Natalia Olano wrote:
> Hello,
> 
> I am looking for some advice regarding the use of the USRP2 and I hope
> that you can help me. Please forgive my inexperience, it is very short
> that I have been working on this area. The USRP2 I am using has an RFX
> 2400 daughterboard, the environment is Suse 10.3 and these are the
> steps I have followed:
> 
> 1/ Installed boost library 1.36 as explained in the readme and added
> it to LD_LIBRARY_PATH
> 
> 2/ Installed Microblaze compiler as explained in the wiki and added it to PATH
> 
> 3/ Installed the gnuradio trunk version 9831
> ./bootstrap
> ./configure --with-boost=$BOOST_PREFIX
> make
> make check (all test passed)
> make install


You need to install the current usrp2 firmware (what you just built)
onto the SD card.  usrp2/firmware/apps/txrx.bin is the file that
should be installed into the s/w slot of the SD card.
See the USRP2 FAQs.  I suspect the info's in there somewhere...

Eric