Re: [Discuss-gnuradio] usrp_wfm_rcv.py failed to set initial frequency error

[Halil Yigit]

Thanks Brian
Flex2400 supports 2.3GHz-2.9GHz. And when I test usrp_wfm_rcv.py -f 2400M there is no error message 'failed to set initial frequency' but other warnings are still there:
 1. FYI: No powermate or Contour  Knob
 2. (python 6931): GnomePrintCupsPlugin-WARNING **: The CPUS printer couldnt be created

----- Original Message -----
From: Brian Padalino <address@hidden>
Date: Friday, August 8, 2008 4:39 pm
Subject: Re: [Discuss-gnuradio] usrp_wfm_rcv.py failed to set initial frequency error
To: Halil Yigit <address@hidden>
Cc: address@hidden

> On Fri, Aug 8, 2008 at 9:15 AM, Halil Yigit 
> <address@hidden> wrote:
> > Hi
> >
> > I'm new to the GNURadio, so I'm trying to get some of the
> > basic tests. I am using Flex 2400 daughterboard
> 
> This is important later on ...
> 
> > I've run the dial_tone.py example, and it is running. for 
> usrp, I have
> > tested usrp_wfm_rcv.py. I've connected daughterboard to RXB 
> and TXB.
> > Then I write ./usrp_wfm_rcv.py -f 96.5M, I get an error 
> message as follows
> >             1. FYI: No powermate or Contour  Knob
> >             2. Failed to set initial frequency  (on USRP WFM RX screen)
> >             3. (python 6931): GnomePrintCupsPlugin-WARNING **: The CPUS
> > printer couldnt be created
> 
> ... as it seems you're trying to tune a Flex 2400 to 96.5MHz.
> 
> You need to either:
> 
>   - Tune to a frequency the Flex 2400 can tune
>   - Acquire a board that can tune to the frequency of 
> interest (96.5MHz)
> 
> Brian