[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Discuss-gnuradio] Problems with burn-db-eeprom
From: |
John Stralka |
Subject: |
Re: [Discuss-gnuradio] Problems with burn-db-eeprom |
Date: |
Mon, 13 Aug 2007 09:07:15 -0700 (PDT) |
I reinstalled the trunk version of GNU Radio, and I was able to successfully
burn the RFX 2400 to MIMO A. The problem I have now is that I cannot seem to
get the daughterboard to tune on receive in either a Rev 3 USRP or a Rev 4
USRP. I've verified that it is reporting MIMO A in the USRP Diagnostics within
GRC, but when I run usrp_fft.py on the MIMO A board, I get "Failed to set
initial frequency".
I tried putting at MIMO A (side B) and a MIMO B (side A) RFX 2400 in a single
Rev 4 USRP. Interestingly, I am able to transmit a tone via a MIMO A card and
receive it in a MIMO B card. But I cannot receive the tone transmitted by the
MIMO B card on the MIMO A card due to this "Failed to set initial frequency"
problem. The MIMO B board's tone is fine. This is how I was testing them.
./usrp_fft.py -R B -d 256 -f 2.4375e9 -g 10 & ./usrp_siggen.py -f
2.437550e9 -i 512 --const -T A
When I burned the MIMO A card, I used the following command:
./usrp/host/apps/burn-db-eeprom -f -A -t rfx2400_mimo_a
Is there something I should check? I'm at a loss on how to proceed. Any
suggestions would be appreciated. Thank you.
John
____________________________________________________________________________________
Yahoo! oneSearch: Finally, mobile search
that gives answers, not web links.
http://mobile.yahoo.com/mobileweb/onesearch?refer=1ONXIC
____________________________________________________________________________________
Take the Internet to Go: Yahoo!Go puts the Internet in your pocket: mail, news,
photos & more.
http://mobile.yahoo.com/go?refer=1GNXIC
- Re: [Discuss-gnuradio] Problems with burn-db-eeprom,
John Stralka <=