[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Discuss-gnuradio] byte-wide ADC transfers
From: |
Clark Pope |
Subject: |
Re: [Discuss-gnuradio] byte-wide ADC transfers |
Date: |
Sat, 18 Feb 2006 18:10:41 -0500 |
In rx_buffer.v I see the 8-bit transfer mode but it only seems to me that it
allows doubling the number of channels transferred not doubling the rate on
the two channels? I want to get 16 MHz bandwidth into my PC. I am able to
run 8 MHz, 16-bit I/Q fine in usrp_fft.py so I figured I should be able to
do 16 Mhz, 8-bit I/Q since it is the same byte rate over USB but I still
can't get it to work.
i.e.
always @*
if(bitwidth == 5'd8)
case(store_next)
4'd1 : begin
fifodata[7:0] = ch_0[15:8];
fifodata[15:8] = ch_1[15:8];
end
4'd2 : begin
fifodata[7:0] = ch_2[15:8];
fifodata[15:8] = ch_3[15:8];
end
seems to me that selecting 8-bit sends Ch0-3 whereas 16-bit sends Ch0-1?
I still haven't tracked down why the make_format isn't showing up either,
btw.
Thanks,
Clark
----Original Message Follows----
From: Eric Blossom <address@hidden>
To: Clark Pope <address@hidden>
CC: address@hidden, address@hidden
Subject: Re: [Discuss-gnuradio] byte-wide ADC transfers
Date: Mon, 13 Feb 2006 14:20:35 -0800
On Sun, Feb 12, 2006 at 07:15:19PM -0500, Clark Pope wrote:
> I still have not gotten this to work. I looked in cvs for
> gr-usrp/src/usrp.py and there is nothing in there about setting the
format?
> I do see it supported in the firmware.
Are you sure that your copy of usrp is up to date?
Please update from CVS (and ensure that it's successful.)
usrp is coming off of source forge which has been *very* flaky recently.
Summary:
update and build usrp
update and build gr-usrp
try again
Eric
_________________________________________________________________
Dont just search. Find. Check out the new MSN Search!
http://search.msn.click-url.com/go/onm00200636ave/direct/01/
- Re: [Discuss-gnuradio] byte-wide ADC transfers, Clark Pope, 2006/02/12
- Re: [Discuss-gnuradio] byte-wide ADC transfers, Eric Blossom, 2006/02/13
- Re: [Discuss-gnuradio] byte-wide ADC transfers,
Clark Pope <=
- Re: [Discuss-gnuradio] byte-wide ADC transfers, Eric Blossom, 2006/02/18
- Re: [Discuss-gnuradio] byte-wide ADC transfers, Clark Pope, 2006/02/19
- Re: [Discuss-gnuradio] byte-wide ADC transfers, Eric Blossom, 2006/02/19
- Re: [Discuss-gnuradio] byte-wide ADC transfers, Clark Pope, 2006/02/20
- Re: [Discuss-gnuradio] byte-wide ADC transfers, Eric Blossom, 2006/02/20
Re: [Discuss-gnuradio] byte-wide ADC transfers, Eric Blossom, 2006/02/13