[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Discuss-gnuradio] Regarding USRP examples
From: |
shweta vishwakarma |
Subject: |
[Discuss-gnuradio] Regarding USRP examples |
Date: |
9 Aug 2005 06:41:45 -0000 |
Hi all,
1) We are running the USRP examples on USRP board fsk_tx.py and fsk_rx.py on one PC. During execution we are receiving too much of noise, what might be the reason?.any solution?
2) Can we run both fsk_tx.py and fsk_rx.py simultaneously on the same PC or do we need to run them on two different PCs ?
3) While running nbfm_ptt_quick_and_dirty.py we are receiving lot of noise. Please provide some solution?
4) As suggested in the USRP document , We are using the antenna with following specifications
1. Electrical Characteristics:
Operating Frequency 2.4~2.5 & 4.9 & 5.15~5.35 & 5.725~5.85 GHz
Antenna Type: Dipole
Polarization Type : Linear
Type of Radiation: Toroidal
Peak Gain 2.0 dBi Typical For 2 G 4.0 dBi Typical For 5 G
Impedance: 50 Ohm nominal
V.S.W.R. 2.0:1 Max.
2 . Mechanical Characteristics
Swivel : 90 degrees
Connector: SMA(M)
Core : N/A
[Prev in Thread] |
Current Thread |
[Next in Thread] |
- [Discuss-gnuradio] Regarding USRP examples,
shweta vishwakarma <=