RE: [Discuss-gnuradio] using a 48k sound card with wfm_rcv_gui

[Richard Cagley]

Tried that and didn't work.
I also tried with the basic RX card. I just put a wire in the middle of the
RX-A SMA connector but nothing came out there either.
Very odd.

> -----Original Message-----
> From: 'Eric Blossom' [mailto:address@hidden
> Sent: Monday, May 02, 2005 10:53 AM
> To: Richard Cagley
> Cc: address@hidden
> Subject: Re: [Discuss-gnuradio] using a 48k sound card with wfm_rcv_gui
> 
> On Mon, May 02, 2005 at 11:12:07AM -0700, Richard Cagley wrote:
> > That worked. Thanks.
> > But, I still only get static (I even have an actual antenna hooked up to
> the
> > TV card). Is it because of the warning I'm getting?
> >
> > address@hidden usrp]$ wfm_rcv_gui.py 93.7
> > RX d'board A: TV Rx
> > RX d'board B: <none>
> > usrp_standard_rx::set_decim_rate: WARNING rates > 128 result in
> incorrect
> > gain.
> > >>> gr_fir_fff: using SSE
> 
> Since you are using the TVRX daughter board, you should be using the
> tvrx_wfm_rcv_gui.py program.  wfm_rcv_gui is for people with no RF
> front end.
> 
> Eric