Hi,
I'm having problems getting chicken-setup to run on a
new installation on Windows Vista. I finally managed
to get it to build after replacing the MSYS dll and csi
works fine - I've tried using some extensions and they
are okay too. However, chicken-setup fails with a
"Bad file number" error. According to this page at
Microsoft:
http://www.microsoft.com/technet/prodtechnol/windows2000serv/reskit/w2000Msgs/5006.mspx?mfr=true
that means it was unable to open a file. I've set all the
folders to read/write and full access and it still fails.
Any ideas on what it might be trying to open, or is
there some way to single-step chicken-setup in the
interpreter to find out where it fails?
Thanks,
Ian
$ csi -:c
/ / /
___ (___ ___ ( ___ ___
| | )| | |___)|___)| )
|__ | / | |__ | \ |__ | /
Version 2.6 - windows-mingw32-x86 - [ dload ptables applyhook cmake ]
(c)2000-2007 Felix L. Winkelmann
#;1> (exit)
$ chicken-setup
sh: /c/packages/chicken/bin/chicken-setup: Bad file number
_______________________________________________
Chicken-users mailing list
address@hidden
http://lists.nongnu.org/mailman/listinfo/chicken-users