bug#35529: libdrm fails to build on armhf-linux

[Ricardo Wurmus]

Mark H Weaver <address@hidden> writes:

> Ricardo Wurmus <address@hidden> writes:
>
>>> Ricardo Wurmus <address@hidden> writes:
>>>
>>>> Mark H Weaver <address@hidden> writes:
>>>>
>>>>> Hydra failed two consecutive attempts to build libdrm on armhf-linux:
>>>>>
>>>>>   https://hydra.gnu.org/build/3481547#tabs-summary
>>>>>
>>>>> Both build attempts were made on hydra-slave2, which is a Wandboard Quad
>>>>> based on the Freescale i.MX6 SOC.
>>>>
>>>> This has built fine on berlin.  We have a completed build for
>>>> /gnu/store/3c28p8b07709isd9jlcnnnyrpgz4ndz8-libdrm-2.4.97.
>>>
>>> What kind of hardware was it built on?
>>
>> I’m not sure.  We’re using a few Overdrive 1000 machines that have quite
>> a bit more RAM than the other armhf nodes.
>
> Are there any other kinds of build slaves that build armhf binaries for
> Berlin?

Yes.  We have a Beagleboard (x15.sjd.se), which is set up for 2 parallel
builds and we use the Qemu service on 5 of our x86_64 machines to build
for armhf.  (We do the same for aarch64, but using 5 different nodes.)

“nss” failed its tests when built on x15.sjd.se, but it worked fine when
building on one of the Overdrives.

--
Ricardo