[avrdude-dev] Issue flashing Atmega2560 using Raspberry Pi (linuxgpio). File size is 152kb.

[Mike Brandon]

Hello,

I receive a verification error when avrdude is verifying the flash of a
file I am sending to an Atmega2560. I can use AVR Studio to flash the same
chip with the same file and it is successful. I can also flash the chip
with avrdude when the file size is smaller ( I haven't tested too many
different files but I wanted to point out that my raspberry pi setup has
been successful with this same chip using avrdude).

Below is the output when using avrdude:


If I try and verify the flash with AVR Studio I receive the following:

​
​
Any advice or pointers to a solution would be greatly appreciated.

Thank you,

Mike Brandon
​