Re: [avrdude-dev] Using a FT232HL in slow bitbang mode

[René Liebscher]

Hi,

currently only FT232R/FT245R are supported, for other chips one had to 
extend this module.

René


On 06.06.2013 21:44, "Ing. Daniel Rozsnyó" wrote:
> Hi,
>   how can I make use of pins AC3~AC7 on a FT232HL for bitbang 
> programming an AVR?
>
>   I naturally tried to count the pins in order AD0..AD7,AC0-AC9, but 
> avrdude is complaining:
>
>
> $ avrdude -p atmega32 -c prob-hand -P usb -b 9600
> avrdude: BUFF: Following pins are not valid pins for this function: 16
> avrdude: RESET: Following pins are not valid pins for this function: 12
> avrdude: SCK: Following pins are not valid pins for this function: 13
> avrdude: MOSI: Following pins are not valid pins for this function: 15
> avrdude: MISO: Following pins are not valid pins for this function: 14
>          Pin assignment  : 0..7 = DBUS0..7
>            VCC     =  (not used)
>            BUFF    =  16
>            RESET   =  12
>            SCK     =  13
>            MOSI    =  15
>            MISO    =  14
>            ERR LED =  (not used)
>            RDY LED =  (not used)
>            PGM LED =  (not used)
>            VFY LED =  (not used)
>
> avrdude done.  Thank you.
>
>
> CONFIG:
>
>
> programmer
>   id    = "prob-hand";
>   type  = "ftdi_syncbb";
>   connection_type = usb;
>   usbvid = 0x0403;
>   usbpid = 0x6014;
>   reset = 12;
>   sck   = 13;
>   miso  = 14;
>   mosi  = 15;
>   buff  = 16;
> ;
>
>
> Is there a trick or the support is just not there?
>
> Thanks,
>
> Daniel
>
> _______________________________________________
> avrdude-dev mailing list
> address@hidden
> https://lists.nongnu.org/mailman/listinfo/avrdude-dev