[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [avr-gcc-list] reset disable (rstdisbl)
From: |
Jamie Morken |
Subject: |
Re: [avr-gcc-list] reset disable (rstdisbl) |
Date: |
Sat, 08 Oct 2005 23:10:10 -0700 |
----- Original Message -----
From: Jamie Morken <address@hidden>
Date: Saturday, October 8, 2005 11:01 pm
Subject: [avr-gcc-list] reset disable (rstdisbl)
> Hi,
>
> If the "rstdisbl" fuse is programmed on an AVR,
> is there any way to unprogram this bit over the
> SPI ISP interface? I have an atmega168 qfp32 chip
> that I am trying to get the fuse bits programmed
> on, but I think I messed up! I should probably
> figure out how to use avrdude I guess, anyone have
> any tips for programming atmega168 fuses? I am using
> an ISP windows program by Adam Dybkowski.
>
> Also for running a 20MHz ceramic resonator, is
woops!.. accidently hit send..
is it better to use the "full swing crystal
oscillator" or the "low power crystal oscillator"
setting when using a 20MHz ceramic resonator?
thanks,
Jamie
>
>
>
> _______________________________________________
> AVR-GCC-list mailing list
> address@hidden
> http://lists.nongnu.org/mailman/listinfo/avr-gcc-list
>