Re: [avr-gcc-list] supply pins on atmega32

[Peter Bosscha]

On the SS issue;
 
Note that you can only use it as an output.
Configure it as an input and you hang your micro, together with some
very strange behaviour on other pins.
 
Peter
 
 

>>> Reza Naima <address@hidden> 15/09/2004 04:07:13 >>>
I made a dumb mistake, and as a result, the supply pins on the TQFP 
atmega32 are all wrong. I am ordering a new PCB, but until it gets 
here, I wanted to see if I could salvage the current board for some 
testing. First off, the atmega32 has 3 VCC pins, and 4 GND pins. Do 
they all have to be supplied for the circuit to work, or can I get by 
with just one? I was also wondering, should the AREF and AVCC be 
attached to something? 

One other question -- can I retask the SS pin (PB4) as a
general-purpose 
IO if I'm using SPI as master only?

Thanks,
Reza

_______________________________________________
avr-gcc-list mailing list
address@hidden 
http://www.avr1.org/mailman/listinfo/avr-gcc-list 


-- 
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.
MailScanner thanks transtec Computers for their support.