Re: [avr-gcc-list] development board

[Douglas Dotson]

Check out www.avayan.com. It has a connector for
RS-232 but no driver. Easy enough with a MAX232.
There is a motherboard available as well and it 
does have a MAX232 and connector on board. I've
been using both on my current project with good
results. Cheap too!

Doug

--- David Morrison <address@hidden> wrote:
> Hi all,
> Could someone reccomend an AVR development board
> that is compact yet brings the GPIO pins out so the
> user can access them?  Oh, it would also need to
> have at least 1 UART (or USART).
>  
>  I have experience using the CANDIP product (based
> off of the ATMega162) but being that I do not need
> the CAN interface for this project (and it is tying
> up a couple GPIO pins) it would be overkill.  
>  
> I appreciate any suggestions.
>  
> dave
>  
> btw: reason I am not going with the 300 or 500
> prototype boards is that they are to big for the
> application that I have in mind and I am not a
> hardware developer so developing my own is out too.
> 
> 
> I have always wished that my computer would be as
> easy to use as my telephone. My wish has come true.
> I no longer know how to use my telephone.
>       -Bjarne Stroustrup, computer science professor,
> designer of C++
>        programming language (1950- )
> _______________________________________________
> avr-gcc-list mailing list
> address@hidden
> http://www.avr1.org/mailman/listinfo/avr-gcc-list


_______________________________________________
avr-gcc-list mailing list
address@hidden
http://www.avr1.org/mailman/listinfo/avr-gcc-list