[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [AUCTeX] Auctex in ELPA is a bit old. Recommended version?
From: |
Max Henner Gerlach |
Subject: |
Re: [AUCTeX] Auctex in ELPA is a bit old. Recommended version? |
Date: |
Fri, 1 Jun 2012 19:58:32 +0200 |
Hi Ralf,
thanks for your answer!
2012/5/31 Ralf Angeli <address@hidden>:
> The site you mention is likely the only source providing pre-compiled
> snapshots. The only other option to get a recent AUCTeX would be to get
> the sources via CVS and compile them yourself.
OK, so I can take it that the current CVS snapshot is the recommended
way to go at this point?
> Regarding the problem you mention, maybe the snapshot is not
> installed correctly? Did you run `make' and `make install'?
I wanted a local user specific install of Auctex
to `~/.emacs.d/auctex` and therefore ran
`./configure --prefix='/home/gerlach/.emacs.d/auctex'
--with-lispdir='/home/gerlach/.emacs.d/auctex/elisp'
--with-texmf-dir='/home/gerlach/.emacs.d/auctex/texmf'`
followed by `make` and `make install`.
I have now investigated my issues further. Apparently they were caused
by some other conflicting entry in my init.el, a minimal
initialization file just with the basic Auctex/Reftex setup works
fine. For now I cannot yet say what went wrong. But I was to hasty to
attribute it to the development version.
> After opening a LaTeX file, are there any errors in the *Messages*
> buffer? Or do you see errors if you start emacs with --debug-init?
Strangely there was nothing.
I will stick with this version of Auctex for now and try to
investigate what caused these bugs to appear on my Emacs.
Thanks for the support!
Max
[Prev in Thread] |
Current Thread |
[Next in Thread] |
- Re: [AUCTeX] Auctex in ELPA is a bit old. Recommended version?,
Max Henner Gerlach <=